ACO FUNKI Egebjerg MASTER Chain, Manual

Page: 10 / 24

09-11-2018 · ACO FUNKI · Tlf. 97119600 · www.acofunki.com Page 10
MASTER CHAIN
®
FEEDING SYSTEM
Splicing sleeves
Mount splicing sleeves with the screws pointing upwards to prevent feed loss. Where joints are made
outdoors, the splicing sleeve must be turned, placing the screws on the side of the tube to avoid water
percolation. If the joints are required to be completely tight, tighten with silicone.
Bends
Feed bends are mounted so that the cover with the wing screw points downward, and the direction indication on
the inner wheel is in accordance with the transport direction of the feed.(60 mm inner wheel does not have a
predetermined rotating direction). If the rotating direction on the corner wheel is incorrect, too much resistance
will build up in the system over time, and the system may subsequently break down.
Without / With
Rotating direction
When mounting the feed pipes, make sure to push them all the way to the stop in the corners.
Feed outlet
When the feed system has been assembled, mark up for outlet holes where feed outlets or feed dispensers are to
be placed. Drill the outlet holes in the feed pipe using a tapered drill. See the size in the table.
Deburr the holes in the feed pipe on the inside and outside.
Mount the top cap of the feed outlet on top of the feed pipe, then tighten the feed outlet using a Parker’s
screwdriver.
Note!
Always tighten using a hand-held screwdriver, allowing the gate to move freely back and forth.
Do NOT use a clamping device or drilling machine
Feed pipes A meassure B meassure
38 mm 25 50
50 mm 35 60
60 mm 42 60