![background image](http://html.mh-extra.com/html/acmer/p1/p1_manual_3046717026.webp)
The engraving pattern is reversed due to incorrect software configuration parame-
ters.
雕刻图案颠倒由于软件配置参数错误导致的
Method: Re-import LaserGRBL through the configuration file in TF card.
方法:通过TF卡中配置文件重新导入 LaserGRBL
4.2
4.3 Irregular carving patterns are caused by machine assembly problems.
雕刻图案不规则是由于机器装配问题造成
1. Please check whether the X axis of the engraving machine is parallel to the
bottom frame and whether the bottom frame is parallel and the diagonal size.
请检查雕刻机X轴是否与底部框架平行以及底部框架是否平行以及对角尺寸
2. Please check whether the X-axis laser head module shakes. If there is shaking,
please adjust the eccentric nut of the POM wheel to ensure that the laser head
module slides smoothly.
请检查X轴激光头模组是否有晃动,如有晃动请调整POM轮的偏心螺母来保证
激光头模组滑动是平稳的
The focus position is wrong, adjust the focus according to the teaching video
in the TF card, and then fine-tune the focus according to the actual situation.
焦点位置不对,参照TF卡中的教学视频调整焦点,再根据实际微调整焦点
5. The carving effect is not good, how to deal with it?
雕刻效果不好 ,怎么处理?
5.1
5.2
5.3 The engraving speed is incorrect, reset the speed.
雕刻速度不正确 ,重新设置速度
The power value is set incorrectly, 1000 is the maximum power, reset the
engraving power. You can manually input the command “M3 S1000” to test
the laser intensity.
功率值设置不对,1000为最大功率,重新设置雕刻功率。可手动输入指令“M3
S1000 ”测试激光强度
24