ACM MINI-RX1, Quick Start Manual

Page: 5 / 12

ENGLISH
- 5 -
WIRED INPUTS OPERATING LOGIC
The two wired inputs (P1 and P2) work with HOLD TO RUN logic:
the motor moves up or down as long as the button is pressed.
The motor direction (up/down) depends on the position of the
motor and wiring.
NOTE: during the movement of the motor, if the second
button is pressed, the motor reverses the motion.
TRANSMITTER OPERATING LOGIC
The wireless controls via transmitter operate with UP-DOWN
logic. Each time the buttons are pressed, the operating logic will
be as follows:
UP : CLOSES
a
CLOSES
a
CLOSES
STOP : STOP
a
STOP
a
STOP
DOWN
: OPENS
a
OPENS
a
OPENS
SENSOR ACTIVATION
To activate the sensors function, at least one transmitter must be
stored.
NOTE:
the HURRICANE RS and TYPHOON sensors use one
channel in the memory of the MINI-RX1 module
m
IMPORTANT:
• Anemometer causes inhibition of functioning of both radio
transmitter and external push button for ca. 8 minutes.
• The anemometrical sensor should be installed close to the
awnings, in order to avoid damages in case of very strong
wind.
REMOTE CONTROL MEMORY STORAGE
Up to 30 different channels can be stored on each control unit.
The button SW1 is used to start the data saving procedure in the
desired MINI-RX1 module.
SW1
L2 L1
L1
- the led lights up when you press the SW1 button to store or
clear transmitters
L2 - the led lights up when the MINI-RX1 module receives a code
which is stored in the memory
To record remote controls for a new control unit that drives a
shutter or a sunshade proceed as follows:
CAUTION: the first transmitter recorded determines the direction
of the motor’s movement
1. Press the button SW1 of the module MINI-RX1: the led L1 lights
up
2.
Press and hold down UP and DOWN until the motor starts to
move in a direction: the led L1 turns off
3. Release the buttons: the motor will stop
4.
Press UP or DOWN following the direction the roll-up shutter
moved prior to stopping:
- if the roll-up shutter was rising, press UP; direction acquired:
the UP button raises the roll-up shutter, the DOWN button
lowers the roll-up shutter
- if the roll-up shutter was lowering, press DOWN; direction
acquired: the DOWN button lowers the roll-up shutter, the
UP button raises the roll-up shutter
5. End of programming
To add other remote controls, proceed as follows:
6. Press and hold down the UP and DOWN buttons of a remote
control that is already recorded until the motor starts to move
in a direction
7. Release the buttons: the motor will stop
8.
Press the UP or DOWN button on the new remote control
MEMORY CLEARING BY MEANS OF BUTTON
SW1
This procedure enables to clear all the transmitters stored in the
MINI-RX1 module.
Proceed as follows:
1. Switch off the MINI-RX1 module
2.
Hold the button SW1 and at the same time switch on the
MINI-RX1 module
3. After 2 seconds, release the button SW1: the motor confirms
successful clearing by moving in both directions for half a
second