1 channel stand-alone DVR
SAFETY PRECAUTIONS
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN!
CAUTION : TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT OPEN COVERS.
NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
This label may appear on the bottom of the unit due to space limitations.
The lightning flash with an arrowhead symbol within an equilateral triangle is intended to
alert the user to the presence of uninsulated “ dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intended to alert the user to
presence of important operating and maintenance (Servicing) instructions in the
literature accompanying the appliance.
WARNING : TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE UNITS NOT
SPECIFICALLY DESIGNED FOR OUTDOOR USE TO RAIN OR MOISTURE.
Attention: installation should be performed by qualified service Personnel only in
accordance with the National Electrical Code or applicable local codes.
Power Disconnect. Units with or without ON-OFF switches have power supplied to the
unit whenever the power cord is inserted into the power source ; however, the unit is
operational only when the ON-OFF switch is in the ON position. The power cord is the
main power disconnect for all unites.
29
2. Configuration of single channel stand-alone DVMR
3. Arrangement of RS-484 and RS-232C pic and RS-232C Hex-codes table
MENU
‘M’
SPEED
‘Q’
UP
‘U’
ENTER
‘E’
MARK
‘I’
DN
‘J’
PLAY
‘P’
P/T
‘T’
LEFT
‘H’
PAUSE
‘F’
RIGHT
‘K’
DEFAULT KEY ‘0’
Hex-code table :
Following ASCII codes are for programmers who want to control the DVMR unit via RS-232C port.
If you connect to RS-232C, you can operate DVMR unit using key board of PC, in addition to operation
using operation buttons on the front of DVMR unit. Send [Carrage Return : (13)] after you input every
code.
All ASCII-code are in 1 Byte format.
ALL ABOUT IMAGE RECOGNITION & PROCESSING
1 channel stand-alone DVMR
7. Specification
C o m m
P o r t
1 5
6 9
Pin No.
Division
1
Alarm
2
RS-232
3
RS-232
4
RS-485
5
Common
6
RS-485
7
Relay out
8
Relay out
9
Relay out
Pin arrangement (Alarm/Relay out/RS-232C/RS-485)
Definition
Input
RxD
TxD
SD -
GND
SD +
N.C.
COM
N.O.
Alarm input : Pin #1 & #5
RS-232 : Pin #2, #3, & #5
RS-485 : Pin #4& #6
Relay out : Pin #8 & #9(N.O.)/Pin #8 & #7(N.C.)
RS-232C specification (baud rate/parity/data length/stop bit) : 19200, N, 8, 1