12. BACK/FRONT GABLE ENDS
Remove the corner posts
(Picture 13, page 23)
. Take the corner gable end polycarbonate panel
and place an aluminum “ ” on the bottom
(Picture 12, page 23).
Stand up the sheet on the
base/sill between the upright Poly Bar and the corner. Then bend the panel and slide it into
the top.
Spray the foam if it is sticky.
Re-install the corner post by sliding it along the side of the polycarbonate panel and bolting it
to the base/sill and gutter
(Picture 10, page 23).
The “ ” slips snugly into the corner post at
the base/sill. You can install all the polycarbonate panels before putting on the caps.
The polycarbonate panel beside the door needs an aluminum “ ” on the top and bottom.
Slide the panel into the doorframe
(Picture 11, page 23)
and push it into place.
13. SIDEWALLS
Once the polycarbonate is installed in the roof and gable ends, proceed
to the sidewalls.
Spray the foam if it is sticky.
Stand the sheet up into the bottom track of
the side base/sill. Put “ ” on top of the panel
(see sketch to the right).
Bend the panel and slide the top of the panel behind the gutter edge.
Push the panel against the foam and screw on the caps in the same
manner as you did the roof and gable ends.
14. CAULKING THE GREENHOUSE
If you are not able to do it earlier See page 13), caulk the inside of the
greenhouse along the base. When the foundation is larger that the
greenhouse, do the outside also.
NOTE: Seal the aluminum angle to the
greenhouse foundation only – do not
use caulking to seal the polycarbonate
sheets.
C R O S S C O U N T R Y S E R I E S S T R A I G H T M O D E L • G R E E N H O U S E I N S T R U C T I O N S
– 22 –
P
O
L
Y
C
A
R
B
O
N
A
T
E
S
H
E
E
T
PO
LY
CA
RB
ON
AT
E
SH
EE
T
Summary of Contents for Cross Country Series
Page 1: ...ACF Greenhouses ...
