5A. SEE APPENDIX A FOR TRUSS ASSEMBLY INSTALLATION, IF REQUIRED
6.
POLY BAR WITH A SLIDER (#1 - #2, etc.)
Each Poly Bar is marked with a number to correspond with the number on the ridge. Slide
the bolt into the top of the Poly Bar and line it up with the slot in the ridge. Move up the bolt
and fasten it tight against the ridge. Do the same for the bottom of the Poly Bar. Slide in the
bolt, lay it on the gutter and bolt it on. Do this for all the Poly Bars with sliders and numbers.
Make sure that the bar is tight against the bottom of the gutter.
(See Step 6 Detail, page 17)
7.
VENT FRAME ANGLE
The vent frame angle is 50” long with the ends cut out to fit between the two Roof Poly Bars
with sliders. The vent frame is the same shape as your base/sill. Put the head of the bolt into
the punch out (24” from the top), slide the bolt up and fasten it to the vent frame on the bar.
Make sure that the angle flanges are facing the sidewall (down) and that it is pushed tightly
against the sliders. Do this for all of them.
(See Step 7 Detail, page 18)
8.
POLY BARS
Bolt on all the remaining Poly Bars. Make sure that the top and bottom are tight against the
ridge and gutter.
(See Step 8 Detail, page 19)
9.
TAPE ALL POLY BARS
You are now ready to tape on the 1/8” foam gasket, if you have not done this already.
(See instructions on page 12)
9A. SIDE VENTS, INTAKE SHUTTER AND EXHAUST FAN INSTALLATION
(if necessary).
(See Appendixes A through F, then return to the next page and continue)
– 14 –
C R O S S C O U N T R Y S E R I E S S T R A I G H T M O D E L • G R E E N H O U S E I N S T R U C T I O N S
Summary of Contents for Cross Country Series
Page 1: ...ACF Greenhouses ...
