7
FotoPrisa
1.4 Prepare to print
This section shows you how to prepare the printer for printing
images. Follow these steps when you use the FotoPrisa Printer
to print images.
Step 1- Turn on the printer power
Turn the power switch ON and wait until the printer completes
its self-test. The “READY” LED indicator will first blink for a few
seconds then remain on. If you find the “STATUS” LED indicator
blinking red intermittently after the self-test, go to Chapter 5 to
check if problem occurs within your printer.
Step 2- Replace ribbon cartridge (when necessary)
If the print ribbon cartridge is used up, you can replace the old
cartridge with a new one after the printer is powered on. Refer
to the following steps to change ribbon cartridge:
1.
Open the ribbon cartridge cover. Lift the ribbon cartridge
hook to release the ribbon cartridge.
2.
Gently pull the ribbon cartridge out by holding the handle on
the cartridge.
3.
Before loading the new ribbon cartridge into the printer,
take up the slack by rotating the ribbon roller as shown in
the figure. When doing so, keep away from dust and do not
touch the ribbon.
Ribbon cartridge hook
“READY” LED
“STATUS” LED
Do not replace the ribbon cartridge while
the READY LED indicator blinks.