28
Chapter 2
Changing a Password
1.
Use the
↑
and
↓
keys to highlight the Set Supervisor Password parameter and press the
Enter
key. The
Set Password box appears.
2.
Type the current password in the Enter Current Password field and press
Enter
.
3.
Type a password in the Enter New Password field. Retype the password in the Confirm New Password
field.
4.
Press
Enter
. After setting the password, the computer sets the User Password parameter to “Set”.
5.
If desired, you can enable the Password on boot parameter.
6.
When you are done, press
F10
to save the changes and exit the BIOS Setup Utility.
If the verification is OK, the screen will display as following.
The password setting is complete after the user presses
Enter
.
If the current password entered does not match the actual current password, the screen will show you the
Setup Warning.
If the new password and confirm new password strings do not match, the screen displays the following
message.
Set Supervisor Password
Enter Current Password [ ]
[ ]
Enter New Password [ ]
Confirm New Password [ ]
[ ]
Setup Notice
Changes have been saved.
[Continue]
[
Continue
]
Setup Warning
Invalid Password.
[Continue]
[
Continue
]
Setup Warning
Passwords do not match.
Re-enter password.
[Continue]
[
Continue
]
Summary of Contents for Extensa 5635
