Acer Aspire 6930 Series, Service Manual

Page: 154 / 239

144 Chapter 4
0x72 Check status bits to see if configuration problems were
detected. If so, display error messages on the screen. LBT Core
0x4F Initialize MultiBoot. Allocate memory for old and new MultiBoot
history tables. LBT Core
0xCD Reclaim console vector after HW vectors initialized. LBT Core
0x7D Initialize Intelligent System Monitoring. LBT Core
0x7E The Coprocessor initialization test. Use the floating point
instructions to determine if a coprocessor exists instead of the
ET bit in CR0. LBT Core
0xC1 Check Boot Type (Server BIOS) LBT Core
0x80 Disable onboard COM and LPT ports before testing for
presence of external I/O devices. LBT Core
0xCA Redirect Int 15h to enable target board to use remote keyboard
(PICO BIOS). LBT Core
0x88 Initialize interrupt controller. LBT Core
0x81 Run late device initialization routines. LBT Core
0x87 Initialize motherboard configurable devices. LBT Core
0x85 Display any ESCD read errors and configure all PnP ISA
devices. LBT Core
0x82 Test and identify RS232 ports. LBT Core
0x84 Test and identify parallel ports. LBT Core
0x86 Initialize onboard I/O and BDA according to CMOS and
presence of external devices. LBT Core
0x83 Configure Fisk Disk Controller. LBT Core
0xCE Initialize digitizer device and display installed message if
successful. LBT Core
0x89 Enable non-maskable interrupts. LBT Core
0x8C Initialize both of the floppy disks and display an error message
if failure was detected. Check both drives to establish the
appropriate diskette types in the TrustedCore data area LBT Core
0xCB Redirect Int 13h to Memory Technologies Devices such as
ROM, RAM, PCMCIA, and serial disk (PICO BIOS). LBT Core
0xCD Remap I/O and memory address space for PCMCIA (PICO
BIOS). LBT Core
0x90 Initialize hard-disk controller. If the CMOS ram is valid and
intact, and fixed disks are defined, call the fixed disk init routine
to initialize the fixed disk system and take over the appropriate
interrupt vectors. LBT Core
0x8B Setup interrupt vector and present bit in Equipment byte. LBT Core
0x95 1. Check CMOS for CD-ROM drive present
2. Activate the drive by checking for media present
3. Check sector 11h (17) for Boot Record Volume Descriptor
4. Check the boot catalog for validity
5. Pick a boot entry
6. Create a Specification Packet
LBT Core
0x92 Jump to UserPatch2. LBT Core
POST
Code
Function Phase Component