Index 3
Floppy drives, 2-10
Format disk, 3-20
Front panel, 4-4, 4-7
Front panel connectors, 1-7
Front panel features, 4-4
G
Graphics aperture size, 2-33
H
Hard disk block mode, 2-14
Hard disk size > 504 MB, 2-14
Host adapter BIOS, 3-4, 3-17
Host adapter SCSI ID, 3-8
Host adapter SCSI termination, 3-10
I
IDE controller, 2-19
IDE drives, 2-12
IDE hard disk standby timer, 2-22
IDE primary channel master, 2-6, 2-12
IDE primary channel slave, 2-6, 2-12
IDE secondary channel master, 2-6, 2-12
IDE secondary channel slave, 2-6, 2-12
Initiate sync negotiation, 3-13
Initiate wide negotiation, 3-14
Installing a DIMM, 1-15
Installing a Pentium II processor, 1-10
Installing a system board, 4-12
Installing additional hard disks, 4-19
Installing components on the system
board, 1-8
Post-installatiion instructions, 1-9
Pre-installation instructions, 1-8
Installing drives, 4-15
Additional hard disks, 4-19
Hard disks, 4-15
Removing the frame with installed
hard disks, 4-21
Installing expansion boards, 4-13
Installing hard disks, 4-15
Installing system board components, 1-8
Installing the front panel, 4-24
Installing the left cover, 4-22
Installing the right cover, 4-23
Internal cache (CPU cache), 2-29
Internal cache size, 2-5
Internal components, 4-6
Internal structure, 4-6
IRQ, 2-16, 2-17
J
Jumper and connector locations, 1-4
Jumper settings, 1-5
Jumpers and connectors, 1-4
Connector functions, 1-5
Jumper settings, 1-5
Locations, 1-4
L
Load default settings, 2-41
LS-120 drive compatible as, 2-11
M
Main board ID, 2-8
Main board S/N, 2-9
Major components, 1-2
System board layout, 1-3
Maximum sync transfer rate, 3-13
Memory at 15MB-16MB reserved for, 2-
30
Memory configurations, 1-14
Memory parity mode, 2-30
Memory test, 2-25
