9
Mechanical Installation of door switch:
1.
Find the right place on the door to install
the door switch, preferably around the area
in the doorpost where you find the original
door switch.
Make sure there is minimum around
10-12
mm free space between the door and
the door post when the door is closed
at the place of installation.
2.
Drill a hole of 12.5 mm at the selected
place.
3.
4.
Close the door. Measure the gap between the door and
the door post. Adjust the switch so, when installed, there
is
8.5 mm of space between the switch and the door
or 3 mm between switch and magnet.
5.
Push the plastic holder in the drilled hole and
fix / seal with a bit of PU glue.
6.
Place the magnet on the opposite position on the door.
Drill a hole of 6,5 mm and push in the black magnet
holder with magnet.
We recommend using the plastic holder but you can choose to
fix with the nuts
7.
When installing the switch using the nuts, the switch must
stick out at least 12 mm because of the need for magnetic
flow around the switch.
8.
When installing the switch using the nuts, the switch should
stick out at least 12 mm because of the need for magnetic flow around the switch.
12.5mm
Lead the cable with the door sensor through the
doorpost and stick the switch through the 12.5 mm
hole Place the Switch in the plastic holder. This is a
tight fit. You need to screw the holder around the
switch.
Check that magnet does not touch the switch
when door is closed with high speed and force
(slammed)
