6
Step 2:
Identify the location underneath
the vehicle where the step will be
positioned. Ensure the step can be installed
in the required position without being
obstructed by the chassis or other vehicle
parts. Use tape on the lower edge of the
frame to indicate where the door is to know
where to place the step when working
under the car.
Figure 2
Figure 3
2x
4x
Size 13
Step 3:
Assemble the step by
attaching the two swing assemblies to
the platform. (Fig 3) Slide the platform
in the hooks and fix the M8 bolts.
Figure 4
8
x
25 MM
126 MM
25 MM
Figure 5
Min 100 MM - Max 250 MM
Figure 6
Step 4:
Mark the location for the 8 front fastening
bolts. (Fig 6) The holes for this attachment should be
located on the lower flange of the outer chassis bar of
the vehicle.
Figure 13
M8
Step 7:
Take the 4 flexible mounting brackets supplied with the step (Fig. 11-14). These
brackets can be attached in several ways.
- The brackets should be used to fix the rear side of the step to the bottom of the vehicle. It is
recommended that a sturdy section of the vehicle floor / chassis us used.
- Install the brackets so that they bridge the gap between step and vehicle floor / chassis.
- The M8 studs should be placed as vertical as possible. This fixing requires some technical
knowledge and own interpretation.
- Always try to go as vertically as possible straight up from the fixing point on the rear of the
step to the fixing points on the vehicles floor.
Size 13
2x
Figure 12
4x
Figure 11
Figure 14
90
°
