4
3
Operation
3.1
Deploy Operation procedure
The vehicle should have the parking brake on before the step can be safely operated.
-
The electronics receive a signal from the door switch or the driver switch.
-
If a door switch is installed the step will move out automatically once the door is opened.
-
Time needed for, either full deploy or stow cycle, is approximately 1,5 seconds.
-
When the step is moving, the red LED on the dashboard will flash until the step is
completely out.
When the step encounters an obstacle it automatically stops and moves
back in. The dashboard LED and buzzer change from slow blinking mode
in fast blinking mode indicating step is not out
3.2
Stow operation procedure
To stow the step the door should be closed or the driver has to give a signal that the step should
stow. The same rules apply as for moving out.
When the step is closed, the Red LED light at the dashboard will go off. It is save to drive away
when the red LED is off.
When the step encounters an obstacle it automatically stops and moves back
out. Than it tries to close again. It tries this 3 times. After 3 times it stops in
outer position. The dashboard LED and buzzer change from slow blinking
mode in fast blinking mode indicating step is not closed
Light blinking = Step is moving
Light on = Step is open
Closed
Light off
