ACS-61100 User’s Manual
LCD Panel (optional) Installation
Read the pre-installation notices earlier in this chapter before proceeding.
1. Remove or open the system case to
allow access to the 51/4
”
drive bay you
are going to use for the LCD panel.
2. Remove the blanking plate from this
slot.
3. With the cables connected to the back
of the LCD panel, slide the panel into
the system case.
4. Secure the LCD panel using screws on
either side.
5. Connect the cables to the card.
6. Go to the
Card Installation
.
Battery Backup Module (Optional) Installation
1. Open the case of the host computer
and remove a blanking plate from the
rear.
2. Connect the cables of the BBM to the
61100 card, as shown.
3. Secure the BBM to the space left by the
blanking plate.
4. Close the case.
The BBM is approximately 2cm high; ensure that your computer case has
sufficient room.
20
Summary of Contents for ACS-61100
