Accorroni S Series, Operation And Installation Manual

Page: 8 / 40

Swimming Pool Heat Pump – S series
INSTALLATION
Installation information
The following information given here is not an instruction, but simply meant to give the user a
better understanding of the installation.
Condition of installation
The following information given here is not an instruction, but simply meant to give the user a
better understanding of the installation.
Installation place
Install the swimming pool heat pump on a flat, horizontal, and stable surface. Maintain 1 M of
open space in front of the discharge grids and 3 M on the outlet side of the ventilator. And
reserve enough space to allow access to temperature controller.
Make sure that the discharged air will not be breathed in.
To perfect your installation
--Avoid directing the flow of ventilated air towards a sensitive noise zone, such as room window.
--Avoid positioning pool heat pump on a surface that can transmit vibrations to dwelling.
--Try to avoid placing appliance under a tree or exposed to water or mud, which would be likely
to complicate maintenance.
Water connection
The heat pump is connected to a filtration circuit with a by-pass.
It is imperative that the by-pass is placed after the pump and the filter.
The by-pass generally consists of 3 valves.
This makes it possible to regulate the water flow which passes through the heat pump and to
isolate the heat pump completely for any maintenance work, without cutting the flow of filtered
water.
If your installation is equipped of a water treatment with product adductions (chlorine,
brominates, salt…) the by-pass must be installed before the water treatment, with a non-return
valve between the by-pass and water treatment.
Operation and Installation Manual 7 2016/02