Then open a browser on your computer and go to
. You should see the following
page:
The settings page allows you to change the IP address and sub-net. Make sure that all equipment on
your network have unique IP addresses.
By pressing the reset button on the device for 3 seconds or more, you will recon;gure the unit to the
factory default IP address and sub-net mask. No other settings will be changed.
Access via Internet
The Cores are network based and therefor could be accessed via the Internet. There are two ways to
achieve this: Port-Forwarding and VPN.
Port-Forwarding is relatively easy to setup in your router. Each router is diFerent so you are advised to
consult the router's documentation (sometimes it is revered to as NAT or Port-Redirecting). Please note
that port forwarding is not secure, anybody could access your Art IO/Art SSC this way.
Accessing via a VPN (Virtual Private Network) tunnel requires a bit more to setup, also your router
needs to support the VPN feature. Once setup, this is a very secure way to communicate with your Art
IO/Art SSC.
6
Art SSC home page
Art IO home page
