East and negative for West. The website
http://www.;ndlatitudeandlongitude.com/
can help you ;nd
the latitude and longitude values for your location.
The time-zone and perhaps daylight saving time of your location is expressed in the UTC (Coordinated
Universal Time) value. UTC is – in this context – equivalent to GMT (Greenwich Mean Time).
For example, Acclaim Lighting' HQ is based in the city of Haarlem, the Netherlands. During the winter
we are UTC +1 and in the summer during day light saving time we are UTC +2. So, our settings are:
The OFset ;elds allows you to shift the sunrise and sunset triggers, both earlier and later. For example,
to have a trigger half an hour before sunrise you set the oFset to -00:30.
DMX INPUT
Only 50 channels are monitored on the DMX Input for triggering individual actions. You can specify here
where that range starts, by default it starts at channel 1.
UDP
In this section you can set the port number on which the Art SSC will listen out for UDP messages. The
IP addresses and port numbers for outgoing UDP messages are set in the tasks at the Show Control
page.
OSC
Set the port number on which the Art SSC will listen for OSC messages in this section.
Also you need to ;ll in the addresses of the devices you would like to be receiving the OSC messages
being sent out by the Art SSC. In these IP Out ;elds you enter both IP address and port number; in the
following syntax: “ipaddress:port”. E.g. to send OSC messages to your device at 192.168.1.99 and port
number 7070, you would ;ll in: “192.168.1.99:7070”.
You can specify up to 4 addresses. Fill in “0.0.0.0:0” in each ;eld you do not need to use.
IP
For setting up the IP address and sub-net mask of the Art SSC. The 'Router' ;eld is only required when
doing Port Forwarding.
32
