Acclaim Lighting AL Dot, User Manual

Page: 4 / 18

2
www.acclaimlighting.com
INTRODUCTION
WELCOME
Welcome to the AL Dot range from Acclaim Lighting. These compact, aluminum bodied,
wet location (IP66) fixtures are self-contained DMX/RDM nodes which emit singular dots of
dimmable light. When used in multiples, they can create a large scale, low resolution graphic
display.
AL Dots are available in two white light options (3000K or 4000K) as well as RGB and
Spectrum RGBW (W=3000K) color mixing variants. There are three lens options to suit your
installation type: Clear flat, diffused flat or diffused dome. Each AL Dot features a large screw
threaded body (diameter 1.73”/44mm) with two aluminum locking rings to allow for panel
mounting, where necessary.
Each AL Dot comes complete with an integral T-cable which combines power (24VDC) and
control (DMX/RDM) to make it simple to daisy chain multiple units. All connectors are IP67
rated and feature secure locking to promote reliable operation in all conditions.
Each AL Dot is fully configurable using RDM (Remote Device Management) and can be
assigned to any DMX address (a single address is required for each white light model,
while the RGB and Spectrum RGBW versions require 3 and 4 DMX addresses respectively).
A maximum of 50 AL Dots may be joined in a single daisy chain (due to power bus
restrictions), however, this limit can be extended by using the optional power feed T-cable
(see page 8).
SAFETY
•
Ensure that the power input is supplied from a correctly fused, grounded and
environmentally protected location.