Acclaim Lighting AL Dot, User Manual

Page: 7 / 18

5
www.acclaimlighting.com
INSTALLATION
AL Dots are primarily designed to be mounted within surfaces that are no greater than 0.71”
(18mm) in thickness . A hole of diameter 1.81 to 1.89” (46 to 48mm) is required.
TO MOUNT AN AL DOT
1 Unscrew and remove the first (rear) locking ring from the AL Dot body.
2 Carefully slide the locking ring along the AL Dot’s cable and T-piece so that it is
completely detached.
3 Feed the AL Dot’s cable and T-piece through the pre-prepared mounting hole and insert
the body of the AL Dot into the hole.
4 Use the front locking ring to determine how deep into the mounting surface the AL Dot
should sit.
5 Feed the removed locking ring back onto the cable/T-piece and screw it back onto the
body of the AL Dot to tighten it within the mounting surface.
6 Connect the AL Dot to your power and control source (see page 6).
Mounting hole Ø1.81 to 1.89” (Ø46 to 48mm)
Locking rings
Mounting surface
maximum thickness
0.71” (18mm)
Threaded section
1.24” (31.5mm) in length