Access RAD ASMi-54, Installation And Operation Manual

Page: 58 / 126

Chapter 4 Configuration Installation and Operation Manual
4-8 Configuring for Operation ASMi-54 Ver. 1.0
4.2 Configuring for Operation
This section explains how to operate the unit.
Setting Device-Level Parameters
This section includes procedures for setting the configuring fault propagation
options.
Configuring Fault Propagation
When the Network > User Fault Propagation feature is enabled, the LAN ports are
deactivated when the PCS uplink goes down. They will come up again once the
PCS port is resynchronized.
To configure the fault propagation:
1. Select Main Menu>Configuration>System.
The Configuration System screen appears (see
Figure 4-2
).
2. Select Fault Propagation.
The Fault Propagation screen appears (see
Figure 4-12
).
3. Select Network>User Fault Propagation and toggle between Enable and
Disable.
4. Press <S> to save the changes.
ASMi-54
Main Menu > Configuration > System > Fault Propagation
1. Network - > User Fault Propagation (Disable)
S - Save
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-12. Fault Propagation Screen
Configuring Date and Time
The Date and Time screen is used to configure the NTP client parameters.
The NTP client is used as a means to receive the date and time from the network.
When the NTP server is properly configured and accessible, the device displays
the real date and time as was received from the NTP server, instead of the
system uptime, which is the default state.