Manual 104-AIO16A and 104-AIO16E
10
Chapter 2: Installation
You may wish to refer to the printed I/O Quick Start Guide which was included with your product
shipment for specific, quick steps to complete the hardware and software installation.
Software CD Installation
The software provided with this board is contained on one CD and
must be installed onto your
hard disk prior to use.
To do this, perform the following steps as appropriate for your operating
system. Substitute the appropriate drive letter for your drive where you see D: in the examples
below.
WIN98/Me/2000/XP/2003
a.
Place the CD into your CD-ROM drive.
b.
The CD should automatically run the install program. If the install program does not run,
click START | RUN and type
BGLQR?JJ
, click OK or press
-
c.
Follow the on-screen prompts to install the software for this board.
LINUX
a.
Please refer to linux.htm on the CD-ROM for information on installing under linux.
Hardware Installation
Install the software package and set all hardware configuration jumpers (refer to Chapter 3, Option
Selection) before plugging the hardware into the system. The SETUP Program can also be used to assist
in configuring jumpers on the board. Be especially careful with Address Selection. If the addresses of two
installed functions overlap, you will experience unpredictable computer behavior. To help avoid this
problem, refer to the FINDBASE.EXE program installed from the CD. The setup program does not set the
options on the board, these must be set by jumpers.
Caution! * ESD
A single static discharge can damage your card and cause premature
failure! Please follow all reasonable precautions to prevent a static
discharge such as grounding yourself by touching any grounded
surface
prior to touching the card.
