Accent 800 User’s Guide: NuVoice
28
Mounting a NuPoint Module
Important!
The NuPoint module must be securely attached to the device with all screws to operate properly.
If you purchased a NuPoint module with your device, the module is already mounted on the device. If you
purchased the module later, follow these instructions to attach it to the device. You can attach the module
to a device with or without a frame.
Note:
Your device may look slightly different from the device shown in these photos.
1.
Using a Phillips screwdriver, remove the device handle or port cover. See “Removing or Reattaching
the Handle” on page 15 or “Attaching the Top Port Cover” on page 15. You will use the screws you
remove from the handle or port cover to fasten the NuPoint module to the device.
Important!
If the device has a frame attached, remove the two top screws that hold the frame in
place. Otherwise, the NuPoint module will not mount properly. Store these screws in a safe location
or discard them.
Loose screws can be a choking hazard.
2.
Align the connector and screw holes on the NuPoint module with the NuPoint USB connector and
screw holes on the top edge of the back of the device.
3.
Slide the module into place, making the sure the connectors are engaged completely.
4.
Tighten the two screws you removed in step 1 to secure the module to the device.
The NuPoint module is ready to set up for use. For detailed instructions on customizing settings,
refer to the
NuPoint User’s Guide
.
Using a Strap Handle with a NuPoint Module
You can use a strap handle to carry your device when a NuPoint module is mounted on the device.
Attach the strap handle to the strap holders either across the top or diagonally across the back.