E1000 Series Safety and Installation Instructions
SI-00101 v2
17
Seal the RF connectors
If installed outdoors, the LTE and GNSS antenna connectors must be sealed
using 3M (or similar) vinyl electrical tape and butyl mastic tape (not supplied) to
prevent moisture ingress.
Connect the backhaul and power
The E10xx is supplied with a suitable PoE+ injector, as shown in Figure 14.
The PoE+ injector requires a 100-240 VAC, 50-60Hz, supply. It draws less
than 1A.
Once the E10xx has been secured in its final position and (if outdoors) the
grounding cable has been connected, connect the backhaul and power to the
E10xx. The E10xx may be connected to the backhaul via an existing PoE+
enabled Ethernet switch if one is available; otherwise install the supplied PoE+
injector as follows.
1. Place the PoE+ injector in an indoor location (or in a weather-proof
enclosure) that has mains power available. Do not connect the PoE+
injector to the mains yet.
2. Connect the supplied (or longer equivalent) Ethernet cable from the
equipment that locally terminates the backhaul to the DATA IN RJ45
socket on the PoE+ injector (which may be
marked “IN” or similar).
3. Connect a second Ethernet cable (not supplied) which must be Cat 5e
or better, to the DATA & POWER OUT RJ45 socket on the PoE+
injector (which may
be marked “OUT” or similar).
4. Route the second Ethernet cable to the E10xx, ensuring that enough
slack is allowed for to avoid straining the cable. In the E1012/CBRS
variant attach the supplied clamp core onto the cable.
Figure 14: PoE+ injector inputs and output sockets
