4
Function introduction for combination buttons
1. Enery-Saving Function
Under cooling mode, Press "TEMP" and "CLOCK" buttons simultaneously to start up or turn off energy-saving function. When
energy-saving function is started up, "SE" will be shown on remote controller, and air conditioner will adjust the set tempera-
ture automatically according to ex-factory setting to reach to the best energy-saving effect. Press "TEMP" and "CLOCK"
buttons simulataneously again to exit energy-saving function will cancel sleep function.
Note:
Under energy-saving function, fan speed is defaulted at auto speed and it can't be adjusted.
Under energy-saving function, set temperature can be adjusted. Press "TURBO" button and the remote controller won't
send signal.
Sleep function and energy-saving function can't operate at the same time. If energy-saving function has been set under
cooling mode, press sleep button will cancel energy-saving function. If sleep function has been set under ooling mode, start
up the energy-saving function will cancel sleep function.
2. 8C Heating Function
Under heating mode, press "TEMP" and "CLOCK" buttons simultaneously to start up or turn off 8C heating function. When
this function is stared up, " " and "8C" will be shown on remote controller, and the air conditioner keep the heating status at
8C. Press "TEMP" and "CLOCK" buttons simultaneously again to exit 8C heating function.
Note:
Under 8C heating function, fan speed is defaulted at auto speed and it can't be adjusted
Under 8C heating function, set temperature can be adjusted. Press "TURBO" button and the remote controller won't send
signal.
Sleep function and 8C heating function can't oerate at the same time. If 8C heating function has been set under cooling
mode, press sleep button will cancel 8C heating function. If sleep function has been under cooling mode, start up the *C
heating function will cancel sleep function.
Uder F temperature display, the remote controller will display 46F heating.
3. Child Lock Function
Press "
▲
" or "
▼
" simultaneously to turn on or turn off child lock function. When child lock function is on, " " icon is dis-
played on remote controller. If you operate the remote controller, the " " incon will blink three times without sending signal
to the unit.
4. Temperature Display Switchover Function
Under OFF status, press "
▼
" and "MODE" buttons simultaneously to switch temperature display between C and F.
Operation Guide
1. After putting through the power, press "ON/OFF" button on remote controller to turn on the air conditioner.
2. Press "MODE" button to select your required mode. AUTO, COOL, DRY, FAN, HEAT.
3. Press "
▲
" or "
▼
" button to set your required temperature (Temperature can't be adjusted under auto mode.)
4. Press "FAN" button to set your required fan speed: auto, low, medium, and high speed
5. Press "SWING" button to select fan blowing angle.
Note:
During operation, point the remote control signal sender at the receiving window on indoor unit.
The distance between signal sender and receiving window should be no more than 8m, and there should be no obstacles
between them.
SIgnal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote controller should
be close to indoor unit during operation.
Replace new batteries of the same model when replacement is required
When you don't use remote controller for a long time, please take out the batteries
If the display on remote controller is fuzzy or there's no display, please replace batteries
Replacement of batteries in remote controller
1. Press the back side of remote controller marked with " ", as shown in the
fig, and then push out the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+"
polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Summary of Contents for AWH30LB-D3DNA3D/I
Page 2: ......
