Abus 17787, Operation Instructions Manual

Page: 18 / 37

Page 18 Data : 01.03.2016
Output relay test
Switch contact status Display Note
Error dis-
play
Test
point
Lift Lower Fast
Monito-
ring
- - 0 - 0 0 0 0 0001 all relays at rest 0000
- - 1 - 1 0 0 0 1000 relays set to ”lift” 1001
- - 2 - 0 1 0 0 0100 relays set to ”lower” 0101
- - 3 - 0 0 1 1 0011 relays set to ”fast”
Part- load switch test
- - 4 -
External part load switch test currently not active
- - 5 -
Input test “E6” / “E2” / “E7” / “EA”
Input status Display Note
Error dis-
play
E6 E2 E7 EA
- - 6 - 0 0 0 0 4000 no signal at inputs monitoring ok 0000
1 0 0 0 0001 ”lift” signal at input 4000
0 1 0 0 0020 ”lower” signal at input 4000
1
0
0
1
1 1
0301
0320
”fast” and “lift” signal at input
”fast” and “lower” signal at input
4000
Input test “E1” / “E3” / “E4” / “E5”
Input status Display Note
Error dis-
play
E5 E4 E3 E1
- - 7 - 0 0 0 1 0005 signal at input E1 evaluated 0000
0 0 1 0 0060 signal at input E3 evaluated 0000
0 1 0 0 0700 signal at input E4 evaluated 0000
1 0 0 0 8000 signal at input E5 evaluated 0000
(0 = contact open, 1 = contact closed)
You must leave this parameter following each test.
For safety reasons, a time limit has been incorporated
for this parameter. When this parameter has been se-
lected for 45 minutes, the unit is switched automatically
back to normal operation.
To leave the diagnosis parameter, press the Enter key
for some time.
Parameter: P 3.0 Display mode – load indication
(in t)
When this parameter is selected, the last load measu-
red is indicated.
Measurement and display are only possible with the
motor running. When the motor is shut down, the dis-
play is frozen.If the motor is started up again, the dis-
play is updated.
When this parameter is selected, the unit switches to a
special mode of operation . The overload protection
function of the unit is active but the load is displayed
and not the operating hours.
Parameter: P 3.1 Display mode – rotating field
power (in kW)
When this parameter is selected, the power measured
is indicated.
Measurement and display are only possible with the
motor running. When the motor is shut down, the dis-
play is frozen.
Parameter:
P 3.2
Display mode – load indication
(in t)
This has the same function as parameter P3.0 except
that the overload protection function is disabled .
Parameter: P 3.3 Display mode – conductor cur-
rent (in A)
When this parameter is selected, the conductor current
measured is indicated.
Measurement and display are only possible with the
motor running. When the motor is shut down, the dis-
play is frozen. If the motor is started up again, the dis-
play is updated following the measurement time.