KL II
Series User Manual 22
Note
：
1.The arrow mark on the side of the hemming must point to the module surface;
2.The hemming with LD/RT logo can be installed at the lower left or upper right of the screen;
3.The hemming marked with End has rounded corners. When installing, pay attention to that the
rounded side should be aligned with the upper or lower edge of the screen;
4. The two ends of the hemming with Middle are right angles, and it is installed in the middle
section of the left or right hemming;
5. When installing the left or right side hemming, use the hexagonal screw to pass through the
hole on the cabinet body from the inside to the outside to fix it.
The upper and lower sides of the screen are wrapped around and installed with hexagon socket
countersunk screws:
Note
：
1. The arrow on the hemming should point to the module surface;
2. The hemming with T/D logo can be installed in the upper/lower position of the screen;
3. When installing the upper and lower side hemming, use the hexagon socket countersunk
screw to pass through the hole on the edging from the outside to the inside and fix it.
hexagon socket
countersunk
screws
