STEP 5.
JA-3
JP
CB-2850
USING THE JA-3 JOINER ANGLE AS A TEMPLATE,
DRILL TWO 10mm HOLES IN EACH END OF THE
CROSS BEAM. SECURE TWO JA-3 JOINER ANGLES TO
EACH END OF THE CROSS BEAM WITH TWO M10 x 20mm
BOLTS, NUTS AND WASHERS. THE JOINER ANGLES
SHOULD BE FLUSH WITH THE TOP OF THE CROSS BEAM
TO ACHIEVE A LEVEL SURFACE TO ATTACH THE
ROOF SHEETS TO.
LEVEL SURFACE TO ATTACH ROOF SHEETS TO.
REAR
FRONT
POSITION THE JOINER PLATE (JP) ON THE EDGE BEAM TO THE DIMENSIONS
SHOWN ABOVE, AND DRILL TWO 10mm HOLES IN THE EDGE BEAM. MOVE THE
JOINER PLATE TO THE INSIDE OF THE EDGE BEAM, TO ACT AS A LARGE
WASHER FOR THE BOLTS. SECURE THE CROSS BEAMS TO THE EDGE BEAMS
AS SHOWN BELOW WITH TWO M10 BOLTS,
NUTS AND WASHERS AT EACH END.
MARK THE POSITIONS FOR THE REMAINING CROSS BEAM ON THE
EDGE BEAMS.
890
880
880
880
880
890
5500
ABSCO INDUSTRIES
ASSEMBLY INSTRUCTION MANUAL
CARPORT MODEL: CPSW50
10-05-2017
Absco Industries
Skillion Carport Model: CPSW50
PAGE 10
