STEP 5.
JA-3
JP
CB-2850
REAR
FRONT
5500
1355
40
1335
40
40
1335
1355
POSITION THE JOINER PLATE (JP) ON THE EDGE BEAM TO THE
DIMENSIONS SHOWN ABOVE, AND DRILL TWO 10mm HOLES IN THE
EDGE BEAM. MOVE THE JOINER PLATE TO THE INSIDE OF THE EDGE
BEAM, TO ACT AS A LARGE WASHER FOR THE BOLTS. SECURE THE
CROSS BEAMS TO THE EDGE BEAMS AS SHOWN BELOW WITH TWO
M10 BOLTS, NUTS AND WASHERS AT
EACH END.
USING THE JA-3 JOINER ANGLE AS A TEMPLATE, DRILL
TWO 10mm HOLES IN EACH END OF THE 2850mm CROSS
BEAM. SECURE TWO JA-3 JOINER ANGLES TO EACH
END OF THE CROSS BEAM WITH TWO M10 x 20mm
BOLTS, NUTS AND WASHERS THE JOINER ANGLES.
SHOULD BE FLUSH WITH THE TOP OF THE CROSS BEAM
TO ACHIEVE A LEVEL SURFACE TO ATTACH THE ROOF
SHEETS TO.
MARK THE POSITIONS FOR THE REMAINING CROSS BEAM ON THE
EDGE BEAMS.
LEVEL SURFACE TO ATTACH ROOF SHEETS TO.
ABSCO INDUSTRIES
ASSEMBLY INSTRUCTION MANUAL
CARPORT MODEL: CPSW33-41
10-05-2018
Absco Industries
Skillion Carport Model: CPSW33-41
PAGE 10
