ABNOX AXFP2-Light Series, Operating Manual

Page: 23 / 108

23
EN
CAUTION
Excessively high follower piston
plate pressure (Figure F/no. 15) can
cause the follower plate to drop
down below the level of the media
and  cause a loss of grease and
contamination.
CAUTION
Closing the bleed valve is essential .
Air can be sucked in or grease pus-
hed out if the bleed valve is open.
The drum pump starts lifting up if
the bleed valve is open in the Hold
position.
Lubricant pumping
• Turning the switch (Figure F/no. 12) to the START-
position starts the pump.
CAUTION: In order to avoid pressing against air, the
control lever (Figure B/no. 5) must be set to
Lower-  . Use the pressure gauge / pressure
regulator (Figure F/no. 13) to adjust the pump
pressure if necessary.
Move the follower plate out of the container.
• Interrupt the air supply to the pump by turning the
switch (Figure F/no. 12) to the STOP- position.
• Set the control lever to Raise  (Figure I/no. 5)
until the follower piston plate (Figure E/no.11) has
automatically moved out of the container.
• CAUTION: If the follower piston plate cannot be
lifted all the way out of the container, please initiate
the following steps:
1. Open the bleed valve (Figure B/no. 6) on the
follower piston plate (upward movement).
2. Set the control lever (Figure B/no. 5) to Raise 
until the pump lifter has been raised all the way
(mechanical stop).
3. Check the seals on the follower piston plate
(Figure E/no. 11) for damage and clean them.
Container changeover
After moving the follower plate out of the container:
• Remove the empty container.
• Slide a full container against the drum stops
(Figure D/no. 10) and centre it
WARNING
Don‘t touch the edge of the con-
tainer or reach into the container
under any circumstances while
lowering the follower piston plate.
This may result in material damage
and/or bodily harm.
Packing, Transport and Storage
The product will be prepared for transport to its first
destination by ABNOX. The packing unit may not be
subjected to any excess load. The packaging and
its content must be protected from moisture. The
transport temperature must be kept between – 20°C
and + 40°C.
Transport Damages
If transport damages are discovered during the
inspection of incoming goods, this procedure must
be followed:
• Inform delivering party (freight carrier, etc.)
• Make record of damages
• Inform supplier
Storage
Storage and temporary storage in aggressive or
humid environments or outdoors can lead to
corrosion and other damages. The storage
temperature must be kept from – 20 °C to +40°C.
Training of Personnel
Only trained and instructed personnel who have read
and understood all points of the Operating Manual
may work on the product. Likewise the individual
operating states must be mastered, and the related
safe aspects must be known and they must be able
to implement them. Personnel undergoing training
may only work on the product under the supervision
of qualified personnel.