Charging procedure –
Manual RFID card administration |
41
Charging procedure
After installation and configuration, the eMH2 is ready for operation immediately, and can now be used to charge an
electric vehicle.
Please follow these steps to charge your vehicle using the Wallbox eMH2:
1
Park your electric vehicle so that its charging inlet can be easily reached with the charging cable's charging con-
nector.
2
Check the LED indicators of the wallbox:
y
When the wallbox is ready for operation, the green
LED pulsates.
3
Prepare the charging cable of the wallbox and the ve-
hicle's charging inlet.
y
Wallbox with charging cable
Slightly lift up the charging connector and pull it
downwards from its storage compartment. Open
the charging inlet at the vehicle and plug in the
charging connector.
y
Wallbox with charging socket
Open the charging inlet at the vehicle and plug in
the charging connector. Then open the charging
socket lid on the wallbox and plug in the charging
connector.
4
Check the LED indicators of the wallbox:
y
If the wallbox is waiting for authorisation of the
charging procedure by the user, the green LED is
ON.
NOTE
Operating the Wallbox eMH2 with or without backend
Depending on the model variant, the Wallbox eMH2 can be operated with or without a backend.
Controller variant:
An eMH2 Controller wallbox must always be operated with a backend.
Extender variant:
An eMH2 Extender wallbox may be operated with a Controller and its backend, or, by
modifying its configuration, as a stand-alone wallbox without backend.
5
Hold a valid RFID card in front of the RFID icon on the
housing cover.
