Abicor Binzel xFUME COMPACT, Original Operating Instructions

Page: 34 / 188

EN - 34
6 Decommissioning xFUME
®
PRO/xFUME
®
COMPACT
5.3 Regulating the extraction volume, Fig. 3
► Observe the operating instructions for the fume extraction system.
► Push air slide to the front
(3) = close, max. extraction volume at the
suction nozzle.
► Push air regulator to the rear (4) = open, reduced extraction volume at
the suction nozzle.
6 Decommissioning
1 Stop the welding process.
2 Wait until the shielding gas post-flow time has passed and switch off the
power supply.
3 Close the shielding gas cylinder valve.
7 Maintenance and cleaning
7.1 Replacing wear parts, Fig. 6
► Order data and part numbers for the equipment parts and wear parts
can be found in the current order documents.
The torch neck can be fitted with various wear parts depending on the
welding task at hand.
The gas nozzle and retaining spring are inserted. All other wear parts are
screwed on.
7.2 Selecting and attaching the wire guide
1 Select the welding materials appropriate for the welding task at hand.
2
Attach the wire guide appropriate for the welding materials you are
using.

Steel: Shortening and mounting the spiral liner, Fig. 5

Stainless steel, aluminum, copper, nickel: Mounting and shortening the PA
liner, Fig. 4
7.2.1 Shortening and mounting the spiral liner, Fig. 5
1 Lay out the cable assembly straight.
2
At the torch neck: Remove wear parts.
3 At the central plug: Unscrew the nut.
4
At the central plug: Remove the spiral liner, replace it with a new one and
insert it into the wire conduit as far as it will go.
5 At the central plug: Manually tighten the nut.
6
At the torch neck: Use a cutter to cut off excess spiral liner so it is flush with
the outlet opening.
7 At the central plug: Unscrew the nut.
8
Remove the spiral liner again.
9 Deburr and grind down the edge at the spiral liner (angle approx. 40°).
10
At the central plug: Insert the spiral liner in the wire conduit again as far
as it will go.
11 At the central plug: Manually tighten the nut.
12
At the torch neck: Mount the wear parts.
 4.3 Connecting the cable assembly, Fig. 1 on page EN - 33
NOTICE
Material damage due to overheating
Liquid-cooled cable assemblies can leak if overheated.
► Allow the cooling unit to continue running for approx. 5 min. after the welding process.
WARNING
Risk of burns from hot surface
Welding torches become very hot during welding. This may result in serious burns.
► Allow welding torches to cool down after welding.
► Wear the correct protective gloves.
CAUTION
Risk of injury due to unexpected start
If power is supplied during maintenance, cleaning or disassembly, parts can start running unexpectedly and lead to injuries.
► Switch off the device.
► Close all supply lines.
► Disconnect the electrical power supply.
NOTICE
Material damage through the use of unsuitable wear parts and mounting tools
The use of wear parts made by other manufacturers and the improper installation of wear parts can cause material damage to the welding torch and impair
work results.
► Use only original ABICOR BINZEL wear parts.
► Use the ABICOR BINZEL wrench for assembling and disassembling wear parts.
► Ensure that wear parts specific to the welding torch are correctly assigned.
► Ensure that the parts are installed in the correct order.