EN - 22
7 Operation
MF1-Laser Front/Rear
7 Operation
8 Decommissioning
1
Switch off the robot control.
9 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
NOTICE
• The system may be operated only by qualified personnel (in Germany, see TRBS 1203).
• Before connecting the wire conduit to the wire feeder, check whether the proper wire guide (liner or
PA liner) in accordance with the wire diameter and wire type has been inserted.
NOTICE
• As the MF1-Laser Front/Rear front drive is integrated into a welding system, the process for
decommissioning it depends on the robot control system. Make sure that the shutdown procedures for
all components integrated in the welding system are strictly observed.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly,
and repair work:
• Switch off the power source.
• Close off the gas supply.
• Close off the coolant supply.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed, or worn parts.
WARNING
Risk of crushing
Hands can be pulled in and crushed by moving wheels.
• Do not reach into moving wheels.
NOTICE
• Maintenance and cleaning work may be carried out only by qualified personnel (in Germany, see
TRBS 1203).
• Always wear your personal protective equipment when performing maintenance and cleaning work.