BRS-LCi
11 Demontage
FR - 17
11 Demontage
Le démontage doit être effectué uniquement par un professionnel. Avant d'effectuer les travaux de
démontage, veillez à ce que les processus de mise hors service soient respectés. Observez aussi les
éléments intégrés dans le système de soudage.
Défaut
Origine
Solution
Le moteur
pneumatique ne
fonctionne pas
• Alimentation en air comprimé / raccordement du
tuyau interrompu
• Vanne d'arrêt bloquée
• Contrôler toutes les conduites au vérin et tous les
raccords à vis
• Moteur défectueux, remplacer
• Remplacer le distributeur
Nettoyage
insuffisant
• Fraise défectueuse ou usée
• Remplacer la fraise
Des éléments de la
torche ont été
endommagés
• Pièces d'équipement incorrectes
• Contrôler les pièces dépendant de la torche
• Contrôler la profondeur d'insertion de la torche
Pas de pulvérisation • Contrôler le niveau de remplissage
• Remplir le liquide anti-adhérent
Pas de pulvérisation • Alimentation en air comprimé / raccordement du
tuyau interrompu
• Distributeur Y4 n'est pas activé
• Vanne d'arrêt bloquée
• OU la vanne de l'unité de pulvérisation et de
soufflage est bloquée
• Contrôler toutes les conduites au vérin et tous les
raccords à vis
• Contrôler la sortie de signal de la commande du
robot
• Remplacer le distributeur Y4
• OU nettoyer ou remplacer la vanne
Brouillard de
vaporisation
excessif / insuffisant
• Réglage incorrect de la quantité de dosage
• Réglage par l'intermédiaire de la vis de régulation
Brouillard de
vaporisation
insuffisant
• Temps de vaporisation trop court
• Temps de soufflage trop long
• Pression de service trop faible
• Prolonger la sortie de signal de la commande du
robot
• Raccourcir la sortie de signal de la commande du
robot
• Augmenter la pression de service
Pas de brouillard de
vaporisation
• Bouteille vide
• Remplacer la bouteille
Aucune fonction de
soufflage
• Distributeur Y3 n'est pas activé
• Vanne d'arrêt Y3 bloquée
• OU la vanne de l'unité de pulvérisation et de
soufflage est bloquée
• Vérifier la sortie de signal de la commande du robot
• Remplacer le distributeur Y3
• OU nettoyer ou remplacer la vanne
Tab. 11
Dépannage
DANGER
Risque de blessure causée par un démarrage inattendu
Pendant toute la durée des travaux d'entretien, de maintenance, de démontage et de réparation, veiller à
ce que
• la source de courant soit arrêtée.
• l'alimentation en air comprimé soit coupée.
• l'installation de soudage soit complètement arrêtée.
• la fiche secteur soit débranchée.