EN - 28
12 Disposal
ABIPLAS
®
WELD CT Plasma drive
1
Disconnect the cable assembly from the power supply.
2
Remove parts to be disconnected.
12 Disposal
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the product to be properly disposed of, it first must be
dismounted.
See 11 Dismounting on page EN-27
12.1 Materials
This product is mainly made of metallic materials which can be molten in steel
and iron works and are thus almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
12.2 Consumables
Oils, greases and cleaning agents must not contaminate the ground and not
enter sewage systems. These materials must be stored, transported and
disposed of in suitable containers. Please observe the relevant local regulations
and disposal instructions of the safety data sheets given by the manufacturer of
the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the
manufacturer of the consumables.
12.3 Packaging
ABICOR BINZEL
has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
NOTE
• Observe the information given in section 8 Putting out of operation on
