TIG cold-wire feeder
8 Putting out of operation
BAL.0415.0 • 2018-10-22
EN - 25
7.3 Putting into operation
Fig. 20 Overview of connections and control elements on page EN-24
1
.
2
Open the valve on the shielding gas cylinder.
8 Putting out of operation
Fig. 20 Overview of connections and control elements on page EN-24
1
Switch off the main switch
2
Close the valve on the shielding gas cylinder.
9 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
Coolant supply
Gas inlet
Symbol
Description
DANGER
Personal injury and property damage from electrostatic charge
During the ignition process and when welding, the surroundings and individuals may become electrostatically charged.
When earthed objects or devices are touched, this built-up voltage is discharged. Electrostatic discharge occurs.
• Do not touch any metal parts in or on the device during the ignition phase.
• Connect the ABIDRIVE only to properly earthed power sockets.
• Operate the ABIDRIVE only with an intact connection lead with a protective conductor and safety plug.
• Only place the welding torch on insulated materials when it is in use.
NOTICE
• When putting the system out of operation, ensure that the procedures for switching off each of the welding system
components are observed.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly, disassembly and repair
work:
• The entire system must be disconnected from the power supply prior to performing any work on it.
• Close the compressed air supply.
• Close the gas supply.
• Disconnect the mains plug.
