Maintenance
3. Loop the new belt over the
motor pulley first, and place
the opposite end of the belt
on the brush roll pulley.
4. Place the brush roller into the
bottom base with the round
edge of the two end-caps
facing down.
Rotate the brush roller by
hand to make sure the belt is
fitted properly.
5. Place the top cover and
replace the 8 screws on
the bottom.
Clean A Brush Roll Jam
Powerhead Circuit Breaker:
IMPORTANT! DO NOT ATTEMPT TO TOUCH THE BRUSH ROLL OR CLEAR THE BRUSH ROLL OF
ANY OBSTRUCTION WITHOUT SWITCHING THE APPLIANCE OFF AND UNPLUGGING IT FROM
THE OUTLET. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY.
1. Carefully inspect the brush roll for tangled hair, carpet
strings or large debris. Beware of any sharp objects that
may have become lodged in the brush roll area. DO NOT
pull on anything that has jammed tightly around the
brush roll as it may damage the unit.
2. Use scissors to carefully cut these objects off the
brush roll and remove them from the power nozzle.
Each Powerhead is protected against motor burnout by a resettable
circuit breaker. In the event the motor becomes overloaded, the
circuit breaker will open and automatically shut-off the power to
the motor. When this occurs, the motor will stop running.
NOTE:
Be sure to read Safety Instructions. In some cases use pin
to reset circuit breaker.
Circuit breaker
5
