Troubleshooting
Resetting Circuit Breaker:
1. Disconnect unit from the electrical supply.
2. Remove any object that may have stalled the brush roll.
3. Rotate the brush roll by hand to make sure it is not frozen in position.
4. Push reset button downward until it snaps into its original position.
5. Reconnect the Powerhead to the electrical supply of the electrified hose handle.
3. Bearing worn out.
Problem
Motor is not working
1. Electrical connection at hose
coupling not made.
Check the connection between the
electrified hose and the power unit.
2. Power nozzle cord not firmly
plugged into the receptacle on
the hose handle.
Plug cord firmly in
Disconnect power, remove any object
that may have blocked the brush
roller, and reset the breaker.
3. Circuit breaker tripped.
Replace belt
Disconnect power, remove any object
that may have blocked the brush
roller.
Replace the brush and bearing
assmbly by distributor.
2. The brush roller is blocked.
1. Broken or worn belt.
Brush not run
Power nozzle not
picking up well.
1. Clogged air chamber.
Disconnect power, remove the
obstruction.
2. Clogged wand or hose.
Disconnect power, remove the
obstruction.
Replace the brush.
3. Brush is worn out.
Possible cause
Possible solution
6
