Abbriata M100 Series, Use And Maintenance Handbook

Page: 18 / 27

Use and maintenance handbook – ed_07/04/2016
Round baler – M100 / M120 / M150
18
EN
GL
IS
H
For lubrication and greasing, pls follow the
instructions detailed below:
a) The round baler is equipped with a reducer unit
(Fig. 8) that contains 1.3 lt. of SAE 90 oil that
should be replaced after the first 400 hours of use
and then at the start of every harvest season.
b) There are six greasing points:
1. greasing points 5 fig.8/A for hook and spring
lever rotation bushings right and left, to be
greased once a day.
2. greasing point 6 fig.8/A for shear bolt flange, to
be greased once a day.
3. greasing point 3 fig.13 for packer device
connecting rod; to be greased once a day. Of
course the above isen’t valid if you find two
sealed bearings in position 3 / fig.13.
4. greasing point 4 fig.13 for chain front joint block
to be greased every 10 working hours, if
possible, when the rear door is open;
5. greasing point 5 fig.13 for pick-up cam to be
greased every 40 working hours;
6. greasing point 6 fig.13 for pick-up wheel lever
right and left. To be greased every 40 working
hours.
None of the other bearings require greasing as they
are all sealed.
Every 200 hours it is advisable to remove all the
casings around all the transmission chains and check
the correct tension. Use a paintbrush to grease them
(Fig. 14) by using oil mixed with naphta.
In the same way, by using oil mixed with naphta
lubricate the main chain (Fig. 15).
Be careful! Don’t lubricate too much this main chain..
BINDING SYSTEM
"Abbriata
®
" round balers are provided, as standard
equipment, with one twine binding device, and can
be equipped with a “net binding device” or “double
twine binding device” or “double binder” on request.*
The threading system of the twine is shown on the
adhesive label applied on the inner front of the
machine (see also drawing of page 8,9,10).
One twine binder has two pulleys (Fig. 16) that
advance the twine carrier at two speeds depending
on the following cases:
1. rapid, for very long products (when the twine is
wrapped around the big diameter pulley);
2. slow, for normal or short products (when the twine
is wrapped around the low diameter pulley).
The diagrams (drawing) of the net binding system is
shown on an adhesive label applied on the inner
front of the machine (see also the drawing page 8).
The diagrams of “double binder” and “double twine
binding device” are shown on an adhesive label
Fig. 13
Fig. 14
Fig. 15
applied on the inner front of the machine (see also drawings of page 9 and 10).
To feed net or twine in the baler to start binding cycle, pls see p.14 item 4.
*”Double binder” isen’t available for “M100” and “M120 Compact”