Abbriata M100 Series, Use And Maintenance Handbook

Page: 15 / 27

Use and maintenance handbook – ed_07/04/2016
Round baler – M100 / M120 / M150
15
EN
GL
IS
H
5. For short products it is advisable to use
the double binding option. To do this, pull
the cutter cord (Fig. 7) which disables the
cutter and enables the twine to go around
the bale twice.
6. When the binding cycle is finished (in the
case of twine binding this is indicated by
the stop in the rotation of the pulley in fig.
6), proceed as follows:
a) stop the P.T.O. * ;
b) move the tractor 5 – 6 m. back;
c) open the rear chamber door (see p.13
item 3 and p.19);
d) re-connect the P.T.O., and drive it
slowly so that the rotation of the rollers
ejects the bale.
7. Close the rear door by means of the
hydraulic lever on the tractor
WARNING!
Be careful when performing the bale unload
door opening and door closing operations.
Perform this operation on a flat surface. The
area has to be large enough to allow for this
operation. Make sure the bale is not able to
roll downhill (no gradient allowed). Also,
make sure no persons or animals are to be
found close to the machine when performing
this operation. Always make sure the round
bale produced is safely on the ground before
taking the machine on the road.
8. A special mechanism / chain front joint
block (Fig. 8) allows to interrupt the
movement of the main chain when
opening the rear door. It is advisable to
grease this mechanism every 10 working
hours (every day).
Fig. 6
Fig. 7
Fig. 8
*It is possible to open and then close the rear door without stopping the P.T.O., taking care of lessening the number of
P.T.O. rears when the rear door is closing in order to avoid excessive stress on the chain front joint block (fig.8).