Do not instal within 10 feet of a pool, spa or fountain
CAUTION:
fixture(s) must be installed in accordance with all local codes and ordinances.
INSTALLATION INSTRUCTION
www.ABBALightingUSA.com
INSTALLATION WITH GROUND SPIKE
When installing the fixture(s), please follow
these instructions carefully:
1.Before installation, please ensure that
the power is turned off for your safety.
2.To unlock or open the fixture, loosen the
screws. Take the replacement metal plate
included in the package. Ensure it has a
hole for the ground spike, allowing for
proper grounding.
3.Attach the metal plate to the ground
spike by aligning the hole and tightening
the screw. Continue tightening the screw
until the metal plate is securely fastened to
the ground spike.
4.Attach the metal plate with the ground
spike to the fixture using screw. Tighten the
screw firmly to ensure a secure connection
between the metal plate and the fixture.
5.Attach the wires from the fixture(s) to the
main cable, For best results, we
recommend using
WN12
waterproof wire
nuts (which are sold separately) to ensure
optimal connectivity and protection
against dust, moisture and water damage.
Simply thread the wires through the wire
nut and twist it until it is securely in place.
6.Strip the insulation: Carefully strip
approximately 3/4 inch (1.9 cm) of
insulation from the ends of the two wires
you wish to connect.
7.Ensure that the bare metal ends are clean
and free from any frayed strands.
8. Align the wires: Hold the stripped ends of
the two wires together, aligning them neatly
and ensuring that no stray strands are
crossing over.
9. Insert the aligned ends of the wires into
the wire nut, ensuring that they go all the
way in. The bare ends should be completely
covered by the wire nut.
10.Twist the wire nut: Firmly twist the wire
nut clockwise onto the wires, ensuring a
secure connection. Continue twisting until
the wire nut is tight and snug. For added
safety, it is recommended to apply electrical
tape around the wire nuts and wires as an
extra layer of protection.
11.Test the connection: Gently tug on each
wire to ensure they are securely held by the
wire nut.
12.Insert the spike into the ground, ensuring
it is vertical and firm., apply enough force to
ensure it is firmly anchored.
13. Remember to test the fixture after
making any adjustments to ensure it is
functioning correctly and that the lighting is
set to your preferences.