66
Entering settings
&KDSWHU
(VWDEOLVKLQJFRQQHFWLRQDQG
YHULI\LQJWKH63$,(&
(QWHULQJVHWWLQJV
If the terminal is connected to a monitoring or control system via the rear SPA/IEC port,
the SPA/IEC port has to be set either for SPA or IEC use.
(QWHULQJ63$VHWWLQJV
When using the IEC protocol, the rear SPA/IEC port must be set for IEC use.
The SPA/IEC port is located at terminal X13 on the rear side of the terminal. Only op-
tical fibres, plastic fibres with connector of type HFBR or glass fibres with connectors
of type ST can be used.
3URFHGXUH
6HWWKHRSHUDWLRQRIWKHUHDU63$,(&SRUWWR³63$´
The operation of the rear SPA/IEC port can be found on the local
HMI at:
&RQILJXUDWLRQ7HUPLQDO&RP63$,(&3RUW
6ZLWFKWKHWHUPLQDORIIDQGRQ
Now the SPA/IEC port operates as a SPA port.
6HWWKHVODYHQXPEHUDQGEDXGUDWHIRUWKHUHDU63$SRUW
The slave number and baud rate can be found on the local HMI at:
&RQILJXUDWLRQ7HUPLQDO&RP63$&RP5HDU
Set the same slave number and baud rate as set in the SMS system
for the terminal.
(QWHULQJ,(&VHWWLQJV
When using the IEC protocol, the rear SPA/IEC port must be set for IEC use.
The SPA/IEC port is located at terminal X13 on the rear side of the terminal. Only op-
tical fibres, plastic fibres with connector of type HFBR or glass fibres with connectors
of type ST can be used.
Summary of Contents for REL 551 2.3 Series
Page 16: ...10 Note signs KDSWHU 6DIHW LQIRUPDWLRQ ...
Page 44: ...38 Checking the binary I O circuits KDSWHU KHFNLQJ WKH H WHUQDO FLUFXLWU ...
Page 52: ...46 Checking the self supervision signals KDSWHU QHUJLVLQJ WKH WHUPLQDO ...
Page 140: ...134 Testing the interaction of the distance protection KDSWHU 7HVWLQJ WKH SURWHFWLRQ V VWHP ...
