ABB IMASI13, Instructions Manual

Page: 97 / 128

6 - 2 WBPEEUI240766B0
Problem Reports
•
If the detailed module status read from the ASI module by
the controller indicates any error conditions.
•
If the channel status for any configured channel indicates
an error.
Table 6-1 contains the error types generated for each error.
Table 6-1. IMASI13 Error Types
Module Problem Report Type 12
Error
Type
Error Description
Analog Input Module
Error
Corrective Actions
14 Calibration (0EH) problem
report (from FC 216) Channel 1-16 disabled Remove IMASI13 and insert. If
error recurs, replace the IMASI13.
Calibration (0EH) problem
report (from FC 215) Cold junction disabled
Calibration (0EH) problem
report (from FC 216) Channel 1-16 not
calibrated
Calibration (0EH) problem
report (from FC 215) Cold junction not
calibrated
7 Configuration mismatch
problem report (from FC 216) Channel not configured Verify that Specs S3 through S9 of
the indicated FC 216 are correct.
3 Channel failure/out of range
(03H) problem report (from
FC 216) Channel 1-16 out of
range error Possible open input or signal is
out of range. Verify field wiring,
connections, sensor and module
seating.
Channel failure/out of range
(03H) problem report (from
FC 215) Cold junction out of
range error
Channel failure/out of range
(03H) problem report (from
FC 216) External cold junction
reference error Verify quality of block defined for
Spec S3.
Channel failure/out of range
(03H) problem report (from
FC 216) Channel 1-16 A/D
conversion error Remove IMASI13 and insert. If
error recurs, replace the IMASI13.
Channel failure/out of range
(03H) problem report (from
FC 215) Cold junction A/D con-
version error