ABB IMASI13, Instructions Manual

Page: 96 / 128

WBPEEUI240766B0 6 - 1
Section 6
Troubleshooting
Introduction
This section explains the error signs and corrective actions for
the IMASI13 module (ASI).
Status LEDs
The IMASI13 module has two LEDs, one red and one green,
that show its operating status. Refer to
Status LEDs Status LEDs Status LEDs Status LEDs
in
Section 5 for a description of their operation.
Alarm and Exception Reporting
No alarm or exception reports are generated directly by the
function codes associated with the IMASI13 module. The val-
ues from the ASI module must be sent to a standard exception
reporting block if exception reporting is required. Refer to the
instruction for the human system interface (i.e., console) being
used for more information.
Problem Reports
Problem reports generated by FCs 215 and 216 are ASI mod-
ule error reports (report type 12). FCs 215 and 216 generate
five kinds of error messages.
•
No response/wrong type (error type 1).
•
Calibration error (error type 2).
•
Channel failure/out of range (error type 3).
•
Calibration (error type 14).
•
Configuration mismatch (error type 7).
Problem reports are generated in response to three types of
errors detected by the function codes.
•
For a communication failure, if any message read by the
controller from the ASI module fails.