6 – EN
CORIOLISMASTER FCX100, FCX400
SEALING OF DEVICES | IN/FCX100/FCX400/MID/OIML-XA REV. A
Lay seal wire
G12352
2
3
1
Fig. 5
1. Insert locking cylinder
3
on the holding rod
1
on the
rear housing cover.
2. Insert the seal wire
2
through the openings on the
holding rod
1
such that both ends are the same length.
3. Tightly twist the seal wire
2
right behind the locking
cylinder
3
to secure the locking cylinder
3
.
NOTICE
You should still be able to slightly move the locking
cylinder after it is secured with the seal wire.
4. Continue to twist the seal wire
2
to the holding rod
1
on the front housing cover. Both ends of the seal wire
must be very close together and the twist loops should
be smaller than 1 cm.
5. Secure the locking cylinder
3
on the front cover, as
described in step 3.
G12354
3
2
1
Fig. 6
6. Continue to twist the seal wire
1
up to the rear head
hole screw
3
. Guide one end of the wire through the
hole in the screw, guide the other end near the screw.
Tightly twist the seal wire
1
right behind the head hole
screw
3
to secure the screw.
7. Continue to twist the seal wire
1
up to the front head
hole screw
2
. Secure the front head hole screw
2
as
described previously.
8. Tightly twist both ends of the seal wire after the front
head hole screw
2
over a length of approx. 5 cm.
9. Place the seal approx. 5 cm from the front head hole
screw
2
onto the ends of the seal wire and press
together using sealing pliers. Cut off any excess
1
seal
wire.
