8 CDPI-01 communication adapter module
Planning the installation
There are two ways to route the cabling to the communication
adapter module:
•
Inside the drive and via the drive bottom plate. See page
.
•
Outside the drive. See page
Necessary tools and instructions
Screwdriver and a set of suitable bits.
If you install the communication adapter module inside the drive,
you need a T20 torx screwdriver for removing the cover and a
cutter/knife for cutting a hole to the rubber grommet at the cable
lead-through.
Selecting the cables
Use straight-connected CAT5e UTP/FTP cables with RJ-45
connectors.
General cabling instructions
•
Arrange the cables as far away from the motor cables as
possible.
•
Avoid parallel runs with the power cables.
