38
AW T4 20 |
U N I V ER S A L 4 - W I R E , D UA L- I N P U T T R A N SM I T T ER | O I/AW T4 2 0 - EN R E V. B
… 13
Configuration (Advanced access level)
Sensor Setup
Used to access standard setup parameters.
Note
.
Sensor Setup
menus are sensor-specific – refer to the
Calibration
section (page 55)
and relevant sensor manual for full details of sensor setup.
Menu
Comment
Default
S1: <Sensor Type>
Note
.
Displayed only if a sensor is fitted to slot 1.
S1: <Sensor Tag>
Access the sensor 1 specific setup pages, refer to the
Sensor setup
section (page <?>).
S2: <Sensor Type>
Note
.
Displayed only if a sensor is fitted to slot 2.
S2: <Sensor Tag>
Access the sensor 1 specific setup pages, refer to the
Sensor setup
section (page <?>).
Hold Outputs
Note
.
Displayed only if two 2-electrode conductivity sensors are fitted.
Access the
Calculated Values
specific setup pages, refer to the
Sensor setup
section (page <?>).
Device Setup
Used to access standard setup parameters.
Menu
Comment
Default
Initial Setup
Instrument Tag
Enter an alphanumeric transmitter identification tag
(16 characters maximum)
AWT420
Temperature Units
Select the units in which all temperatures are displayed:
•
°C/°F
°C
Security Setup
Calibrate Password
Set the password to enable access at
Calibrate
level.
Not factory-set
Advanced Password
Available only at
Advanced
access level.
Not factory-set
Service Access
Service Password
Reserved for use by authorized ABB service technicians
Set at factory
Write Protection
Restore Defaults
Select to restore ALL transmitter configuration parameters to their default values and restart the transmitter.
Sensor Setup
Exit
Menu
Select
Device Setup
Exit
Menu
Select
