![background image](http://html1.mh-extra.com/html/abb/autolink/autolink_mounting-instructions_3382896006.webp)
TEHI95094 – rev. 1
6 / 11
- IEC 60694
- IEC 61936: Electrical Installation
- ANSI C37 63: Automatic Sectionalizer
- All accident prevention regulations in force in relative countries
For special installation requirements or other operating conditions, please contact ABB.
6.3 Initial Setting or Previous Setting Modification Instructions
Remove the contact cap (Fig. 1 A) with a 34mm fork spanner holding the base (Fig. 1 B)
with the hand. Check condition of O-ring (Fig. 2 E), and replace if necessary, applying
grease on it.
Figure 1
With a small screwdriver, set the dip switches for calibrating current (Fig. 2 C, 4 switches)
and Counting Operations (Fig. 2 D, 2 switches), according to settings table 1.
Note: handle with care without forcing the switches. Settings must be made in a clean
and dry environment.
E
C
D
Figure 2