ABB ACS880-604, Hardware Manual

Page: 77 / 134

Ordering information
Contents of this chapter
This chapter lists the types and ordering codes of the unit components.
You can find the kit-specific assembly drawings, step-by-step instructions and detailed kit
information on the Internet. Go to
https://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content . If needed, contact
your local ABB representative.
Note:
• This chapter only lists the installation accessories available from ABB. All other parts
must be sourced from a third party (such as Rittal) by the system integrator. For a listing,
refer to the kit-specific installation instructions available at
https://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content . For access,
contact your local ABB representative.
• Parts that are labeled suitable for generic enclosures are not designed for any specific
enclosure system. These parts are intended as a basis for further engineering, and may
require additional parts to be fully usable.
Installation accessories designed for generic enclosures are in fact designed for an
inside width of 50 mm less than the nominal width of the enclosure. For example, a
mechanical kit intended for 800 mm wide generic enclosure is designed for an inside
width of 750 mm, and will not fit a 800 mm wide Rittal VX25 enclosure.
Kit code key
The kit codes shown in this chapter break down as follows.
The format of the kit code is x-w-s-yyy(-VX), for example, L-6-8-401 where:
• x = cooling method
• A = air-cooled (some of these kits are also used with liquid-cooled drives)
• L = liquid-cooled
12
Ordering information 77