ABB ACS580MV, Hardware Manual

Page: 112 / 146

112 Maintenance
1. Lift the grating and pull it away from the door.
2. Remove the air filter.
3. Place the new filter into the grating.
4. Reinstall the filter and grating in reverse order.
Cleaning heat sinks of power modules
The heat sink fins of the power modules pick up dust from the cooling air. The drive runs
into overtemperature warnings and trips if the heat sink is not clean. When necessary,
clean the heat sink as follows.
WARNING! Obey the instructions in chapter Safety instructions . If you ignore
them, injury or death, or damage to the equipment can occur.
WARNING! Use a vacuum cleaner with antistatic hose and nozzle. Using a
normal vacuum cleaner creates static discharges which can damage circuit
boards.
1. Stop, de-energize and ground the drive following the steps in section Shutting down
the drive for maintenance before you start the work.
2. Ground the power modules according to Grounding power module with grounding
hook on page 107 .
3. Remove the power module from the cabinet. See Replacing the power modules on
page 118 .
4. Blow dry clean compressed air (not humid) from front to back and simultaneously use
a vacuum cleaner at the air outlet to trap the dust. Note: If there is a risk of dust
entering adjoining equipment, perform the cleaning in another room.
5. Reinstall the power module into the drive.
6. Repeat the above steps for all power modules.
7. When the work is completed the drive can be started up again. See Chapter
Operation, Energizing and starting the drive .
1
1 Filter