ABB ACQ580, Firmware Manual

Page: 137 / 422

Parameters 133
13.28 AO2 source max Defines the real maximum value of the signal (selected by
parameter
13.22 AO2 source ) that corresponds to the
maximum required AO2 output value (defined by parameter
13.30 AO2 out at AO2 src max ). See parameter 13.27 AO2
source min . See parameter 13.17 AO1 source min about the
AO automatic scaling.
-32768.0…32767.0 Real signal value corresponding to maximum AO2 output
value. 1 = 1
13.29 AO2 out at AO2 src
min Defines the minimum output value for analog output AO2.
See also drawing at parameter
13.27 AO2 source min .
0.000 mA
0.000 … 22.000 mA Minimum AO2 output value. 1000 = 1 mA
13.30 AO2 out at AO2 src
max Defines the maximum output value for analog output AO2.
See also drawing at parameter
13.27 AO2 source min .
20.000 mA
0.000 … 22.000 mA Maximum AO2 output value. 1000 = 1 mA
13.91 AO1 data storage Storage parameter for controlling analog output AO1 eg.
through the embedded fieldbus interface.
In parameter
13.12 AO1 source , select AO1 data storage .
Then set this parameter as the target of the incoming value
data. With the embedded fieldbus interface, simply set the
target selection parameter of that particular data
(
58.101 … 58.114 ) to AO1 data storage .
0.00
-327.68…327.67 Storage parameter for AO1. 100 = 1
13.92 AO2 data storage Storage parameter for controlling analog output AO2 eg.
through the embedded fieldbus interface.
In parameter
13.22 AO2 source , select AO2 data storage .
Then set this parameter as the target of the incoming value
data. With the embedded fieldbus interface, simply set the
target selection parameter of that particular data
(
58.101 … 58.114 ) to AO2 data storage .
0.00
-327.68…327.67 Storage parameter for AO2. 100 = 1
15
15 I/O extension
module Configuration of the I/O extension module installed in slot 2.
See also section
Programmable I/O extensions (page 47 ).
Note: The contents of the parameter group vary according to
the selected I/O extension module type.
15.01 Extension module
type Activates (and specifies the type of) I/O extension module. If
the value is
None , when an extension module has been
installed and the dive is powered, the drive automatically sets
the value to the type it has detected (= value of parameter
15.02 Detected extension module ); otherwise warning A7AB
Extension I/O configuration failure is generated and you have
to set the value of this parameter manually.
None
None Inactive. 0
CMOD-01 CMOD-01 multifunction extension module (external
24 V AC/DC and digital I/O). 1
CMOD-02 CMOD-02 multifunction extension module (external
24 V AC/DC and isolated PTC interface). 2
CHDI-01 CHDI-01 115/230 V digital input extension module. 3
CPTC-02 CPTC-02 extension module. 4
15.02 Detected extension
module I/O extension module detected on the drive. None
None Inactive. 0
No. Name/Value Description Def/FbEq16